Menu
Your Cart
0
0

Freenove Breakout Board for ESP32 / ESP32-S3 WROVER WROOM, Terminal Block Shield HAT with Pin Header, 5V 3.3V Power Outputs, GPIO Status LED

Freenove Breakout Board for ESP32 / ESP32-S3 WROVER WROOM, Terminal Block Shield HAT with Pin Header, 5V 3.3V Power Outputs, GPIO Status LED
Freenove Breakout Board for ESP32 / ESP32-S3 WROVER WROOM, Terminal Block Shield HAT with Pin Header, 5V 3.3V Power Outputs, GPIO Status LED
New
Freenove Breakout Board for ESP32 / ESP32-S3 WROVER WROOM, Terminal Block Shield HAT with Pin Header, 5V 3.3V Power Outputs, GPIO Status LED
Freenove Breakout Board for ESP32 / ESP32-S3 WROVER WROOM, Terminal Block Shield HAT with Pin Header, 5V 3.3V Power Outputs, GPIO Status LED
Freenove Breakout Board for ESP32 / ESP32-S3 WROVER WROOM, Terminal Block Shield HAT with Pin Header, 5V 3.3V Power Outputs, GPIO Status LED
  • Stock: In Stock
  • Model:
190 samples sold
Product Views: 99
Based on 1 reviews. - Write a review
$12.95

Available Options

Add to Cart
Buy Now Ask Question
Add to Wish List Compare this Product
Connectivity TechnologyGPIO
Included Componentsvarious
Operating SystemEmbedded
CPU ManufacturerFreenove

About this item

  • Compatible Models: Freenove ESP32 / ESP32-S3 series (Note: Not compatible with boards from other brands due to different pinout)
  • GPIO Status LED: LED on if GPIO outputs / inputs high level, LED off if GPIO outputs / inputs low level
  • Independent LED: The status LED is driven by the chip instead of the GPIO so the GPIO will not be affected
  • Power Circuit: Provide multiple 5V and 3.3V power outputs (5V output up to 3A with external power supply)
  • Terminal Block and Header: Connect to all pins of ESP32 / ESP32-S3, 2.54 mm (0.1 inch) pitch

Write a review

Note: HTML is not translated!
Bad Good
Notification Module
This is the sticky Notification module. You can use it for any sticky messages such as cookie notices or special promotions, etc.